Conversions & Units
Cubic Metres to Tonnes
Converts m³ to tonnes for concrete, sand, and gravel by density
Updated 29 April 2026 · Live
What this tool does
Converts m³ to tonnes for concrete, sand, and gravel by density.
People also use
How the cubic metres to tonnes works
Converts m³ to tonnes for concrete, sand, and gravel by density. The calculator takes your dimensions and supplier rates, applies a standard UK trade formula, and returns a quantity with an indicative cost. Every figure is an estimate — site conditions always move the final number.
Typical UK conversions and units wastage
Conversion is exact — wastage only enters when you then order against the converted figure. Apply category-specific wastage to the output rather than the conversion itself. Our defaults reflect common UK trade allowances — adjust upwards for non-standard geometry, downwards if your experience says so.
What this tool does not do
It does not replace a professional quote, factor regional pricing, assess structural adequacy, or confirm Building Regulations compliance. Those remain the responsibility of a suitably qualified designer, surveyor, or your building control officer.
On-site considerations for cubic metres to tonnes
UK trades mix metric and imperial routinely (joists sold in metric lengths but boards priced in ft²). Double-check which unit the supplier is quoting.
Building Regulations and compliance
Building Regulations are published in metric. SI units are the only ones accepted on Building Control submissions. When in doubt, lodge a pre-application enquiry with your local authority — early clarity is cheaper than a retrospective correction.
Before you order
Always note the original unit alongside the converted figure in your quote — it avoids disputes if the supplier works in the other system. Always cross-check the calculator's output against a supplier quote — ask for exact product specifications (grade, finish, batch number) and confirm delivery timescales against your programme.
Adjusting the defaults
Every input in this calculator is editable. Enter your own dimensions, supplier prices, and wastage allowance — the output recalculates instantly. If the defaults feel off for your region or project type, your own numbers always override them.
Using this cubic metres to tonnes alongside other BuildMetricLab tools
This calculator works best as part of a planning workflow. Pair the quantity with our project contingency, labour-hours, and material-cost calculators to build a complete estimate before you pick up the phone to a supplier. All BuildMetricLab tools run entirely in your browser — no sign-up, no data sent anywhere, and every formula is shown on-page so you can audit the maths.
Sources & methodology
Converts m³ to tonnes for concrete, sand, and gravel by density. Uses UK trade defaults for wastage and density. Prices are illustrative April 2026 values; change them to match your supplier quote.
Frequently asked questions
Are cubic metres to tonnes results accurate enough to order materials?
Use them as a starting estimate only. Always verify the final quantity with your supplier or contractor before ordering — site conditions, wastage and cut-offs all affect the true figure.
What wastage percentage should I use?
The calculator defaults to the typical UK trade allowance for conversions & units. Increase it for complex cuts, awkward shapes, or first-time DIY. Reducing the wastage below the default is not recommended.
Does this replace professional advice?
No. This tool is a planning estimator. For works that affect structure, Building Regulations, Party Wall, gas, electrics, drainage to a sewer, or similar, consult a suitably qualified professional.
Can I change the unit prices?
Yes — every price field is editable. Plug in your supplier's quote to get a total that matches your project.
Related tools
Calculators from other categories that planners often reach for next.